11 steps of chain link fence installation step 1.
Chain link fence instructions.
Slide tension bands onto each corner gate and end post.
Chain link fence gate installation instructions figure 2 figure 3 figure 4 step 1 dig terminal post holes approximately 8 in diameter and 30 deep with sloping sides fig.
Step 2 with crayon or chalk mark the ground line on posts.
Most fence installers recommend that all posts be set approximately 4 inside the property line.
Follow the fence manufacturer s instructions for spacing which typically ranges from 4 10 apart spacing should not exceed 10 on center.
Also be sure to determine the property boundary and the local setback rules.
The bands will help hold the mesh in place once it s installed.
Leave the concrete a few inches below ground level.
Mark the fence location before you start have the local utility company mark all underground utility lines.
Chain link fence installation manual before you begin.
Chain link fence posts are typically spaced a maximum of ten feet apart.
Locate your property s line.
As chain link fence posts are smaller and sturdier than many other types the holes should be smaller and can be farther apart.
Use a rubber mallet to drive end post caps onto the gate corner and end.
1 the good thing is that you can dig all the post holes at once.
This will help avoid encroaching on adjoining property with concrete footings.
Slope it away from the post to help with water runoff.
Once you have determined the property line and legal setback mark out the location of the fence.
Mark the fence location.
Check all the regulations about fence setbacks type and height.
Put hinges and latch hardware onto the gate posts at roughly their final positions to install later.
Check out your property line setback requirements.
All posts should be set about 4 inches inside the line.
There may be local zoning or deed restrictions pertaining to height and type of fence.
Find surveyors pins if the fence is to be located near property lines or have the lot surveyed.
This is easily done by stretching a string along the property line and setting the posts 4 inside.
Obtain necessary zoning and building permits.
The key point to remember with chain link fencing is that in order to achieve a rigid strong fence your posts must be concreted in line wire needs to be tensioned along the fence line and the chain link must be tensioned and secured correctly to the posts and line wire.
The exact diameter and depth will be determined by local weather and soil conditions.
If using fast set concrete pour the dry mix around each post to a few inches below ground level and add water.
